Anchor Points
Anchor Points are named geographic references stored per organisation. They are used throughout the dashboard as home points, muster points, safe-landing zones, and simulator start locations.
Muster Points
Muster points are reference locations the aircraft can be directed to in an emergency, or that operators use as rally points during an incident.
Adding a Muster Point
- Click the + icon in the Muster Point(s) heading.
- Enter a Name for the point.
- Enter Latitude, Longitude, and optionally Altitude (metres).
- Alternatively click Set on map to close the Settings panel and click directly on the map.
- Click Save to store the point.
Editing and Deleting
- Click the pencil icon beside a point to edit its coordinates or name.
- Click the × icon to delete the point. Deletion is immediate and cannot be undone.
Displayed Information
Each saved muster point shows:
- Name
- Coordinates (latitude, longitude)
- Altitude (if set)
A copy-to-clipboard button is available next to each coordinate pair.
Simulator Location
The Simulator Location is the starting coordinate used when Simulator mode is activated from the General tab. Only one simulator location is stored at a time.
To change it, click the pencil icon and enter new coordinates, or use Set on map to click the map.
Muster points and the simulator location are organisation-wide, not per-device. All devices in the organisation share the same set.